Your basket is currently empty!
Tag: Andrew Russell
Hifisonix Solid State Loudspeaker Relay
On big power amplifiers, conventional electromechanical relays leave much to be desired when it comes to their ability to reliably switch fault level currents in the event of a catastrophic amplifier fault. In a worst case situation (and I speak from experience), one of the output devices fails short circuit, placing the full amplifier rail voltage across the loudspeaker terminals. Relay…
Opamp Noise Visualizer
This Excel spread sheet tool was developed from one by Steve Hagman (www.AnalogHome.com) and allows en and ien data for up to 7 opamps to be compared. When using the tool, make sure you enter comparable data – so for example, always use the same frequency to make the comparison. I normally use 1 kHz…
Ovation SCA-1: A high performance fully balanced line pre-amplifier
Originally published in 2010 Here is the result of my investigation in to a fully balanced high performance, low distortion line pre-amp, the ‘Ovation’ Stereo Control Amplifier One’. I drew some inspiration for this project after reading about the TEAC Esoteric line preamp, which is also based on the TI PGA2320, and received rave reviews…
Small Signal Audio Line Stage Buffer/Headphone Amplifier
This design, which I completed in 2010, takes an LM4562 and marries it to a hefty single ended class A output stage, which can be biased up for either 50 mA or 110 mA. The output stage is included in the global feedback network and can achieve 1 ppm at 20 kHz into 600 Ohms…