The New HifiSonix Fully Balanced Line Pre-Amp (2)

Ovation SCA-1: A high performance fully balanced line pre-amplifier

 

Originally published in 2010

Here is the result of my investigation in to a fully balanced high performance, low distortion line pre-amp, the ‘Ovation’ Stereo Control Amplifier One’.

I drew some inspiration for this project after reading about the TEAC Esoteric line preamp, which is also based on the TI PGA2320, and received rave reviews from the hi-end press. Esoteric have stuck with the PGA2320 in subsequent models of their line pre-amp and continued to garner excellent reviews. Michael Fremer, of Sterophile fame, said it was one of the best line preamps he had heard at any price – the Esoteric goes for about $10k.

How does my SCA-1 sound?  Very open with a smooth mid and upper range.  DC coupling throughout means there are no nasties in the LF area either, and overall imaging is excellent.

Ovation SCA-1 Circuit Diagrams

SCA-1 Specifications

This design is a dual mono fully  balanced line pre-amp.  Input balanced source selection is via relays,  under CPU control via a serial optically isolated bus. The output from the source selection feeds  into a dual LM4562 high resolution audio op-amp buffer,  and this then feeds  into a TI PGA2320,  which is configured as a balanced volume control stage.  The balanced output from the PGA2320 feeds  into an inverting stage configured around an LM4562,  with each half of the LM4562 driving an LME49600 buffer.  The LM49600’s are inside the LM4562 feedback loop in order to minimize distortion.  Since this pre-amp is DC coupled from input throught to output, a servo configured around an AD8512 dual op-amp ensures output offsets are limited to around 200uV worst case.The  headphone amplifer is built around an LME49710 high resolution audio op-amp,  and the LME49600,  again, the buffer inside the op-amp’s feedback loop for the lowest possible distortion.

The entire pre-amp is controlled by an NXP LPC1768 32 bit ARM controller from mbed (see www.mbed.org).  The controller  is fully  optically isolated from the main analog board in order to ensure there are NO  noise  problems,  with separate optically isolated serial busses for each channel.  The operating program is written in C and ended up at about 120k bytes including the graphics (the actual I/O part is about 20k bytes long) and is interrupt driven,  so when not executing commands  from the front panel controls or the remote control,  the CPU  shuts down,  minimizing noise and power consumption. Of course, the use of the optically isolated serial bus also has a big impact on noise performance,  where I am aimed for something  well under -110dB worst case.